Water Filtration and Treatment Kerry

Components Of A Fully Integrated Rainwater Harvesting System

Posted on

water pump supplier

A rainwater tank is the key aspect of rainwater harvesting system. However, you must consider the various components in the system so that the water quality does not get affected. Thus, identify the important components of rainwater harvesting system before planning to install one.
Remember, the components which are listed below can be of a good quality only if you purchase the rainwater harvesting sytem from a reputed supplier of water treatment systems in Cork.

Gutter Guard Screening
Invest in gutter screens if your home surrounding is prone to bush and trees. It might be a good idea to prevent leaves and debris from building up and blocking the gutters. Free flow of rainwater is obvious.

Rain Head/Leaf Eater
Rain heads are also known as leaf eaters. They deflect leaves and debris to prevent their entry into the pipes that carry water. They are installed just below the gutter downpipe, at the top of the pipework that directs rainwater into the tank.

Tank Screening
It is important to install tank screening to prevent mosquitoes, insects and debris from finding their way into the tank. This screening is installed on top of the tank.

Water Diverter
Installing water diverters is a good idea when your tank water is distributed in the home. When it rains for the first time, it often contains dust and debris. Thus, to divert and flush this dirty water away from the tank, water diverters are a good component.

Rainwater Storage
When choosing rainwater storage, first determine the requirement of water in your house and the storage capacity on the roof. Identify an appropriate site in your property to install the water tank, or you can also opt for multiple short storages.

Tank Overflow
Rainwater tanks have a hole at the top to let out the excess water through a piping connected with it. It is important to divert the water away from the building and other structures to avoid forming moss and damaging them. It is a good idea to design your garden effectively to soak up excess rainwater or install a separate stormwater detention tank where excess rainwater can be stored.

Pump and Filtration
To use tank water throughout the property, a pump is a vital installation. Filtration should also be installed, especially if the water is used for drinking or cooking purpose.

It is important to know about these important components while you are using rainwater. To ensure safe water flow throughout the building, it is recommend to install a rainwater harvesting system from reputed water treatment systems in Cork.

Carbon Boosts The Flexibility Of Reverse Osmosis Water Filter System

Posted on Updated on


One of the most efficient and affordable processes of purifying water is carbon filtration. Carbon filters are highly touted for their performance, mainly because of their physical characteristics. A pound of carbon has the ability of possessing an approximate surface area of about 125 acres. This allows the area to absorb a large amount of pollutants present in the water. This quality is the major factor which makes carbon filters an important feature of many reverse osmosis water filtration systems.

The process
Activated carbon filters are also known as charcoal filters. Actually, the material is charcoal which is treated with oxygen to give the filter high porous properties, This allows the filter to absorb a large amount of water contaminants. When normal water is passed over the carbon, pollutants present in the water literally stick on it and effectively get removed from the water.

The effectiveness
A reverse osmosis water filter system which is provided by reputed water purification companies in Cork, uses carbon filter systems as pre or post filtration mechanisms. This means the filtration is superb and poses to be quite beneficial in eliminating high amount of pollutants. Carbon filters are also effective in removing low molecular weight volatile organic compounds (VOCs), including chlorine and its by-products. This may make the water completely tasteless, but it is also the safest form to drink.

Reputed water filtration companies in Kerry utilise the benefit of carbon filtration process in removing toxic contaminants such as chromium, arsenic and mercury, as well as specific pesticides and industrial solvents. Carbon filtration is the sole component which filters the water effectively. This makes the RO filter systems perfect for residential, commercial and industrial use.

RO system providers can install the perfect filtration system that’s best suited for your needs. This involves various sizes, RO membranes, and filtration systems. All these depend on the quality of the natural water, and the purification requirements of an individual. Make sure that the plastic components are welded properly or else the filtration capabilities of carbon may not be effective. This is why it is recommended to purchase filters only from reputed water filtration and treatment companies in Kerry.

Carbon filters are the next generation filtration systems which treat tainted water quite efficiently.

How To Choose The Best Domestic Water Pump?

Posted on Updated on

Domestic Water Pump

Choosing the correct pump for residential usage is not an easy job. The choice differs from one house to another. If you experience irregularities and scattered directions in the flow of water, it means that there are mainly two considerations needed to be taken into account for overcoming the problems.

If you are looking to extend your home or planning to set up a new water system it would be a smart choice to install a larger pump to cope with the demand. Installing new pumps will ensure correct and adequate water flow to every outlet in the house. It would provide a consistent and continuous flow.

Always remember, switch on your pump only if the water tank holds enough water in it. If the water level is low, air gaps can form in the pipeline which may cause damage to the pump. You might need to replace the entire pump if the water chamber in the pump fills with air. This is why always check the water tank before switching on your pump. You can also install a sensor inside the tank. The sensor comes with an alarming bell which is attached outside the tank. When the water level reaches the sensor, the bell starts to ring. This way you can be aware of the water level without opening the tank.

  1. The first and the foremost consideration is to repair the existing pump. A low grade pump can lead to such problems.
  2. The second thing is to determine the pump’s horsepower. Generally, the horsepower is mentioned on the body of the pump, but in case you do not find one, it is better to call a water pump supplier in Cork.

Generally, the water flow rate for domestic purposes is twenty litres per minute. The size of the pump depends upon the size of the house and the number of water outlets it has.

Finally, the sound of the pump really matters a lot. There are some pumps which have smaller pressure tanks and this creates lot of noise which can be disturbing. Moreover, a pump which creates loud noises consume a large amount of electricity. Therefore, to minimise this, you need to buy an energy saving pump. It comes with a large pressure tank to reduce the extra noise and electricity.

Thus, you can see that installing a perfect pump in your home must be configured properly. However, it can be made easy if you hire a water pump supplier in Cork.

What Do You Understand By Sewage Treatment?

Posted on Updated on

sewage treatment

Sewage treatment involves removal of contaminants and harmful elements from waste water, which is primarily discharged from households. Industrially viable waste water is produced by removal of contaminants through biological, physical and chemical processes.

Sewage, generally speaking, refers to waste water from household toilets, showers, baths, kitchens and sinks that drain into the sewers. Industrial liquid waste from power plants and refineries can also be termed as sewage. Industrial sewage differs from household sewage in its content. Industrial sewage often contains waste that is harmful to the environment if left untreated, whereas household sewage would cause general accumulation of waste water that leads to mosquitoes breeding, which in turn, can bring forth a plethora of diseases.
The most basic aim of any water treatment plant is to produce an affluent which causes as little harm as possible when released into the environment, hence reducing pollution caused by releasing untreated waste water into the surrounding environment.

Pretreatment is used to remove all substances from the sewage that may clog or damage the sewage carrying lines. This is done automatically by a mechanical screen bar in modern plants that serve big populations. The solid waste collected is either incinerated or disposed off in landfills.

Sewage treatment involves three main stages:

Primary treatment: This involves temporarily storing the sewage in a sedimentation basin where the solids can settle down to the bottom while fluids such as grease, oil and lighter solids float up to the surface. This separation allows floating and settled materials to be removed and the liquid can be either discharged or sent for secondary treatment.

Secondary treatment: This process removes suspended and dissolved organic matter. It is performed by indigenous micro-organisms in a controlled environment. Secondary treatment may require a step to separate the micro-organisms from the treated water before discharge or further treatment.

Tertiary treatment: This step is performed only when the water is to be discharged into a fragile or sensitive ecosystem like an estuary, low flow river or coral reef. Water is either disinfected physically or chemically using lagoons or microfiltration before discharging it into any water body like a river, stream or bay.

Odour Control
Odors emitted by a sewage plant are an indication of an anaerobic or septic environment. Early stages are more likely to produce foul smelling gases such as hydrogen sulphide. If the plant is near an urban area, then carbon reactors are used to treat the odours.

A conventional water treatment plant in Cork uses 30% of its annual operating cost on energy requirements. The requirements vary with type of treatment plant. For example, plants near wetlands have lower energy requirement than plants near urban areas because cost of transportation of water through pumps to water bodies is reduced. Similarly, treatment plants that produce biogas from anaerobic digestion can meet all their energy requirements in-house.